Sizing and Equipping

Sizing Instructions

The quickest way to determine your Stubby Buddy Ring size is by measuring your root diameter which will be the roughly the size as your optimal ring size. Utilizing a length of non-stretchable rope or cord(easily the most accessible option is a length of USB cord as they do not stretch like cotton/poly ropes) around the base of the genitals, making sure that both the penis and the balls are included in the loop, until the surrounding skin is comfortably compressed and still allows you to slip 1 finger into the loop. Then mark the point where the rope/cord meets and use a ruler or measuring tape to measure the distance between the marks once the rope is removed and the rope/cord pulled taught. That measurement can then be divided by Pi(3.14) and round up to arrive at the optimal diameter for your root size and your Stubby Buddy Ring size.

For a more accurate experience, we recommend using rope/cord wearing the loop for 1hr+ to better resemble how the ring would look and feel around the genitals and confirm that in various states of arousal blood flow is not fully cut off.

 

How to Wear Your Stubby Buddy

  1. Upon receiving your new Stubby Buddy chastity device, thoroughly clean each part with warm soapy water. Rinse thoroughly to remove any soap residue and let air dry [NOTE: DO NOT USE BOILING WATER]

  2. Once dry and during a flaccid state, insert balls one-by-one through the base ring, making sure that the ball splitter and locking mechanism are both clearly visible at the front.

  3. Insert the penis through the ring (using the same opening as the balls) and gently adjust the genitals to achieve a “cradle” feeling with the ball splitter. The ball splitter should clearly separate one ball from the other and give them a slight “splayed” look. Use a fitment spoon or ringer where the cage locks onto the ring to avoid pinching. Please note that this may take some practice and getting used to if you have not worn a ball-splitter before.

  4. Put the cage section on by:

    A. Inserting the head of the penis into your desired cage, aligning the bottom portion of the cage with the corresponding hole in the ring splitter and pushing the cage firmly towards the ring to latch them together. Make final adjustments to the penis within the cage as needed.

     

    OR

    B. Gently retracting the flaccid penis into the body (effectively “turtling” or “inverting” the penis into the body) and pinching the skin at the tip to hold it in position. Then maneuvering the cage in place over the retracted tip of the penis, let go of the skin allowing the penis to “spring back” into place. This allows more foreskin to make it past the smaller diameter opening of the cage where it will remain even through arousal states. Make final adjustments to the penis within the cage as needed



    [NOTE: to avoid pinching at the balls, place a finger or fitting spoon under the ball splitter hinge before pushing(A) or rotating(B) the cage into the ring]

  5. Once the cage is fitted into the ring and final adjustments are made, insert a keyless lock or brass lock into the mechanism. Enjoy your new chastity device and feel free to share your experiences on social media and on our discord server or contact us via live chat or email if you have any further questions.